General Description
The ICS1893BY-10 is a low-power, physical-layer device (PHY) that supports the ISO/IEC 10Base-T and 100Base-TX Carrier-Sense Multiple Access/Collision Detection (CSMA/CD) Ethernet standards. The ICS1893BY-10 supports managed or unmanaged node, repeater, and switch applications.
The ICS1893BY-10 is intended for MII, Node applications that require the Auto-MIDIX feature that automatically corrects crossover errors in plant wiring.
The ICS1893BY-10 incorporates digital signal processing (DSP) in its Physical Medium Dependent (PMD) sublayer. As a result, it can transmit and receive data on unshielded twisted-pair (UTP) category 5 cables with attenuation in excess of 24 dB at 100 MHz. With this ICS-patented technology, the ICS1893BY-10 can virtually eliminate errors from killer packets.
The ICS1893BY-10 provides a Serial Management Interface for exchanging command and status information with a Station Management (STA) entity.
The ICS1893BY-10 Media Dependent Interface (MDI) can be configured to provide either half- or full-duplex operation at data rates of 10 MHz or 100 MHz. The MDI configuration can be established manually (with input pins or control register settings) or automat i c a l l y (using the Auto-Negotiation features). When the ICS1893BY-10 Auto-Negotiation sublayer is enabled, it exchanges technology capability data with its remote link partner and automatically selects the highest-performance operating mode they have in common.

*Supports category 5 cables with attenuation in excess of 24 dB at 100 MHz
*Fully integrated, DSP-based PMD includes:
-Adaptive equalization and baseline wander correction
-Transmit wave shaping and stream cipher scrambler
-MLT-3 encoder and NRZ/NRZI encoder
*Low-power, 0.35-micron CMOS (typically 400 mW)
*Power-down mode typically 21mW
*Single 3.3-V power supply.
*Single-chip, fully integrated PHY provides PCS, PMA, PMD, and AUTONEG sublayers of IEEE standard
*10Base-T and 100Base-TX IEEE 802.3 compliant
*Highly configurable design supports:
-Node, repeater, and switch applications
-Managed and unmanaged applications
-10M or 100M half- and full-duplex modes
-Parallel detection
-Auto-negotiation, with Next Page capabilities
-Auto-MDI/MDIX crossover correction
*MAC/Repeater Interface can be configured as:
-10M or 100M Media Independent Interface
-100M Symbol Interface (bypasses the PCS)
-10M 7-wire Serial Interface
*Clock and crystal supported
*Small Footprint 64-pin Thin Quad Flat Pack (TQFP)
*Available in Industrial Temperature and Lead-Free

ICS1893BYI-10, ICS1893BY-10LF, ICS1893BYI-10LF

Trackback ::

댓글을 달아 주세요 Comment