General Description
Quad Low-Side Switch in Smart Power Technology (SPT) with a Serial Peripheral Interface (SPI) and four open drain DMOS output stages. The TLE 6220 GP is protected by embedded protection functions and designed for automotive and industrial applications. The output stages can be controlled direct in parallel for PWM applications (injector coils), or through serial control via the SPI. Therefore the TLE 6220 GP is particularly suitable for engine management and powertrain systems.

Features
*Short Circuit Protection
*Overtemperature Protection
*Overvoltage Protection
*8 bit Serial Data Input and Diagnostic Output (SPI protocol)
*Direct Parallel Control of Four Channels for PWM Applications
*Cascadable with Other Quad Switches
*Low Quiescent Current
*μC Compatible Input
*Electostatic Discharge (ESD) Protection

Application
*μC Compatible Power Switch for 12 V and 24 V Applications
*Switch for Automotive and Industrial System
*Solenoids, Relays and Resistive Loads
*Injectors
*Robotic controls

P-DSO-20-12

Trackback :: http://datasheetblog.com/trackback/2340

댓글을 달아 주세요 Comment

General Description
The IXDN430/IXDI430/IXDD430/IXDS430 are high speed high current gate drivers specifically designed to drive MOSFETs and IGBTs to their minimum switching time and maximum
practical frequency limits. The IXD_430 can source and sink 30A of peak current while producing voltage rise and fall times of less than 30ns. The input of the drivers are compatible with TTL or CMOS and are fully immune to latch up over the entire operating range. Designed with small internal delays, cross conduction/current shoot-through is virtually eliminated in all
configurations. Their features and wide safety margin in operating voltage and power make the drivers unmatched in performance and value.
The IXD_430 incorporates a unique ability to disable the output under fault conditions. The standard undervoltage lockout is at 12.5V which can also be set to 8.5V in the IXDS430SI. When a logical low is forced into the Enable inputs, both final output stage MOSFETs (NMOS and PMOS) are turned off. As a result, the output of the IXDD430 enters a tristate mode and enables a Soft Turn-Off of the MOSFET when a short circuit is detected. This helps prevent damage that could occur to the MOSFET if it were to be switched off abruptly due to a dv/dt
over-voltage transient.
The IXDN430 is configured as a noninverting gate driver, and the IXDI430 is an inverting gate driver. The IXDS430 can be configured either as a noninverting or inverting driver. The IXD_430 are available in the standard 28-pin SIOC (SI-CT), 5-pin TO-220 (CI), and in the TO-263 (YI) surface mount packages. CT or 'Cool Tab' for the 28- pin SOIC package refers to the backside metal heatsink tab.

Features
*Built using the advantages and compatibility of CMOS and IXYS HDMOSTM processes
*Latch-Up Protected
*High Peak Output Current: 30A Peak
*Wide Operating Range: 8.5V to 35V
*Under Voltage Lockout Protection
*Ability to Disable Output under Faults
*High Capacitive Load Drive Capability: 5600 pF in <25ns
*Matched Rise And Fall Times
*Low Propagation Delay Time
*Low Output Impedance
*Low Supply Current

Applications
*Driving MOSFETs and IGBTs
*Motor Controls
*Line Drivers
*Pulse Generators
*Local Power ON / OFF Switch
*Switch Mode Power Supplies (SMPS)
*DC to DC Converters
*Pulse Transformer Driver
*Limiting di/dt Under Short Circuit
*Class D Switching Amplifiers

IXDD430YI, IXDD430CI, IXDI430YI, IXDI430CI, IXDN430YI, IXDN430CI, IXDS430SI

Trackback :: http://datasheetblog.com/trackback/2192

댓글을 달아 주세요 Comment