Product Description
The TQ3132 is a low current, 3V, RF LNA IC designed specifically for Cellular band CDMA/AMPS applications. It’s RF performance meets the requirements of products designed to the IS-95 and AMPS standards. The TQ3132 is designed to be used with the TQ5131 or TQ5132 (CDMA/AMPS mixer) which provides a complete CDMA receiver for 800MHz dual-mode phones.
The LNA incorporates on-chip switches which determine CDMA, AMPS, and bypass mode select. When used with the TQ5131 or TQ5132 (CDMA RFA/mixer), four gain states are available. The RF output port is internally matched to 50 Ω, greatly simplifying the design and keeping the number of external components to a minimum. The TQ3132 achieves good RF performance with low current
consumption, supporting long standby times in portable applications. Coupled with the very small SOT23-8 package, the part is ideally suited for Cellular band mobile phones.

Features
*Small size: SOT23-8
*Single 3V operation
*Low-current operation
*Gain Select
*Mode Select
*High IP3 performance
*Few external components
*50Ω Output

Applications
*IS-95 CDMA Mobile Phones
*AMPS Mobile Phones
*Dual Mode CDMA Cellular applications
*832-870MHz CDMA applications
TAG CDMA/AMPS, ic, LNA

Trackback :: http://datasheetblog.com/trackback/2771

댓글을 달아 주세요 Comment

General Description
The MAX2323/MAX2325 are low-noise amplifier (LNA) plus mixer ICs optimized for code-division multiple-access (CDMA) applications in both cellular and PCS bands. The MAX2323 addresses dual-band, triple-mode CDMA applications by providing switched signal paths for cellular FM, cellular CDMA, and PCS CDMA. The MAX2325 is a cellular-band dual-mode version.
To optimize cellular-band dynamic range at minimum current, the MAX2323/MAX2325 implement four LNA states: high gain/high linearity, high gain/low linearity, midgain, and low gain. In high-gain/high-linearity mode, the adjustable high-intercept LNA minimizes desensitization in
the presence of a large interfering signal. For the other gain states, the LNA current is reduced to improve standby time.
The CDMA mixers are designed for high linearity, low noise, and differential IF outputs, while the FM mixer is designed for lower current and single-ended output. Each band is implemented with a separate mixer to optimize performance for the specific band.
The MAX2323/MAX2325 can also be used in TDMA, EDGE, and W-CDMA phones.

Features
- 2.7V Operation
- Dual Band, Triple Mode
- Three LNA Gain Settings (Cellular)
- Two LNA Gain Settings (PCS)
- 18mA in Low-Gain Mode
  19.5mA in Paging and Midgain Mode
  26.5mA in High-Gain, High-Linearity Mode
  16.5mA in FM Mode, High-Gain, Low-Linearity Mode
- 2.5dB (typ) Cascade Noise Figure
- Adjustable LNA IIP3, +5dBm to +13dBm
- Ultra-Small 28-Pin Package (5mm x 5mm)

MAX2325, MAX2323EGI, MAX2325EGI, MAX2323EVKIT
TAG CMDA, LNA, Mixer

Trackback :: http://datasheetblog.com/trackback/152

댓글을 달아 주세요 Comment